dg Posted July 18, 2003 Report Share Posted July 18, 2003 I've always taken the nibb out the opposite end and put a rod in the shaft and use it as a slide-hammer to nock out the unibushing. Or find a punch that will push the remaining nock part into the shaft, remove the nibb and let it fall out. Quote Link to comment Share on other sites More sharing options...
Bob LeBlanc Posted July 18, 2003 Report Share Posted July 18, 2003 Re: Uni-Nock jimt, If it is just the nock...you can make a small pilot hole with a drill in what is left of the nock and then thread a small screw into the hole.Make sure it takes a good bite and then either with pliers or a vise, clamp onto the head of the screw and it should pull right out. If it's the bushing, a lot will depend on the type of adhesive that was used to install it. With hot-melts, you can probably get it out just like dg suggests after heating the shaft. Bob [ 07-17-2003, 08:21 PM: Message edited by: Bob LeBlanc ] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.