Guest Xen Posted December 2, 2004 Report Share Posted December 2, 2004 Hello Danny, welcome to the forums. I am sure you'll find most of these guys just as helpful as I do Quote Link to comment Share on other sites More sharing options...
BuckNrut Posted December 3, 2004 Report Share Posted December 3, 2004 Re: Just got into MLing! You do not mention caliber or twist ration (but let's just say .50 and 1:45 twist). Keeping in line (no pun intended) with bluelk's article I would start to apply its contents. Decide on a powder (FF or 777) start with some round balls (cheaper than conicals) and work up an accurate load with the maximum charge. Refer to the gun's manual for maximum charges and don't go over! If the twist is greater than 1:45 round balls will not be accurate limiting you projectile choice to conicals (if allowed). It's possible if your inline is newer you may not be able to use it (ethically) in an area where sabots are not allowed. Welcome aboard, and good shooting! Quote Link to comment Share on other sites More sharing options...
AJ Posted December 3, 2004 Report Share Posted December 3, 2004 Re: Just got into MLing! [ QUOTE ] .50 cal 1:28 twist ratio! Is that ethical to use? Danny [/ QUOTE ] Quote Link to comment Share on other sites More sharing options...
Nut Posted December 7, 2004 Report Share Posted December 7, 2004 Re: Just got into MLing! [ QUOTE ] .50 cal 1:28 twist ratio! Is that ethical to use? [/ QUOTE ] Yes Danny it is. I'm not a expert but I do know that some type of sabot or even the powerbelts is best for that twist. Read your manual to see what it suggests to use and go from there. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.