birddog Posted November 23, 2005 Report Share Posted November 23, 2005 I shot my ML yesterday and it is shooting 4 inches low and 6 inches left: If I aim at the middle of a piece of paper it hits bottom left hand corner: If I aim at the top right corner I hit the bullseye: Now, I need to remember which way to adjust my sites: I have a top site that says UP with an arrow pointing lcounterclockwise: And I have a screw with a "R" and an arrow pointing clockwise: Anywho, which way do I adjust the site? Do I follow the bullet, like you would with a bow site? I just can't remember how to do it: And it is a pain to clean my ML between each shot when I screw up! Quote Link to comment Share on other sites More sharing options...
Smitteken Posted November 23, 2005 Report Share Posted November 23, 2005 Re: Help on Sighting If you have a scope follow it like you would a bow site. Quote Link to comment Share on other sites More sharing options...
BuckNrut Posted November 23, 2005 Report Share Posted November 23, 2005 Re: Help on Sighting For a scope, the easiest way to sight in is to note a group, then center the crosshairs on the middle of the group. If iron sights, move the rear sight up and to the right. And don't forget to test again. GL. Quote Link to comment Share on other sites More sharing options...
birddog Posted November 23, 2005 Author Report Share Posted November 23, 2005 Re: Help on Sighting Yes, it is Iron SItes: So, I then move them the direction I need to move, or do I move them towards the hole that it is currently hitting? If I am reading this right, I move them TOWARDS the bullseye: I am shooting low and left, so I need to move them up and right? How dumb...that I can't figure this out......I swear I have an edjamacation. :-) Quote Link to comment Share on other sites More sharing options...
Tominator Posted November 23, 2005 Report Share Posted November 23, 2005 Re: Help on Sighting For rear sights pretty sure you move opposite the way you want your zero to go. Post this in the rifle room. AJ will know for sure. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.